Zare, A., Bodisco, T.A., Jafari, M. et al. (8 more authors) (Cover date: 15 February 2021) Cold-start NOx emissions: Diesel and waste lubricating oil as a fuel additive. Fuel, 286 (2). 119430. ISSN 0016-2361
Abstract
NOx emissions from diesel engines are a concern from both environmental and health perspectives. Recently this attention has targeted cold-start emissions highlighting that emission after-treatment systems are not effective in this period. Using a 6-cylinder, turbocharged, common-rail diesel engine, the current research investigates NOx emissions during cold-start using different engine performance parameters. In addition, it studies the influence of waste lubricating oil on NOx emissions introducing it as a fuel additive (1 and 5% by volume). To interpret the NOx formation, this study evaluates different parameters: exhaust gas temperature, engine oil temperature, engine coolant temperature, start of injection/combustion, in-cylinder pressure, heat release rate, maximum in-cylinder pressure and maximum rate of pressure rise. This study clarified how cold-start NOx increases as the engine is warming up while in general cold-start NOx is higher than hot-start. Results showed that in comparison with warmed up condition, during cold-start NOx, maximum in-cylinder pressure and maximum rate of pressure rise were higher; while start of injection, start of combustion and ignition delay were lower. During cold-start increased engine temperature was associated with decreasing maximum rate of pressure rise and peak apparent heat release rate. During cold-start NOx increased with temperature and it dropped sharply due to the delayed start of injection. This study also showed that using waste lubricating oil decreased NOx and maximum rate of pressure rise; and increased maximum in-cylinder pressure. NOx had a direct correlation with the maximum rate of pressure rise; and an inverse correlation with the maximum in-cylinder pressure.
Metadata
Item Type: | Article |
---|---|
Authors/Creators: |
|
Keywords: | Waste lubricating oil, Cold-start, NOx emissions, Diesel engine warm-up |
Dates: |
|
Institution: | The University of Leeds |
Academic Units: | The University of Leeds > Faculty of Engineering & Physical Sciences (Leeds) > School of Mechanical Engineering (Leeds) > Institute of Engineering Thermofluids, Surfaces & Interfaces (iETSI) (Leeds) |
Depositing User: | Symplectic Publications |
Date Deposited: | 05 Oct 2023 10:23 |
Last Modified: | 05 Oct 2023 10:23 |
Status: | Published |
Publisher: | Elsevier |
Identification Number: | 10.1016/j.fuel.2020.119430 |
Open Archives Initiative ID (OAI ID): | oai:eprints.whiterose.ac.uk:203954 |