Coimbra Gonçalves, M.C., Harling, G., Mandazhiev, M. et al. (4 more authors) (2026) Subsurface deformation and residual stress analysis during micromilling of Ti6Al4V using coated and uncoated tools. Procedia CIRP, 144. pp. 144-149. ISSN: 2212-8271
Abstract
The quality of surface produced in micromilling is significantly influenced by the microstructural characteristics of the machined material and its initial stress state. Ploughing becomes a significant part of the chip formation mechanics in micromachining due to the small scale of the removed material relative to the tool geometry, and it can lead to a large residual stress field on the surface. This, however, can be significantly influenced by alterations in the cutting-edge geometry because of tool wear. This study investigates the influence of progressive tool wear on surface and subsurface integrity during the micromilling of Ti6Al4V. Coated and uncoated flat-end micromills were used to manufacture microslots under controlled conditions. Surface integrity was assessed through subsurface microstructure characterisation, residual stress measurements, microhardness and surface roughness analysis. Coated tools favoured material adhesion, leading to higher surface roughness, microhardness, and machining forces. The larger tool edge radius of the coated tools, and therefore greater material deformation under the flank face, led to more ploughing and consequently higher residual stresses at the early stages of the cutting process. In the worn coated tools, the loss of tool material combined with the increased material adhesion promoted a reduction in the effective uncut chip thickness, causing the compressive residual stresses to diminish as the tool wore. Uncoated tools exhibited reduced adhesion, and their sharper edge radius plastically deformed a thinner material layer, resulting in lower compressive stresses and a thinner affected subsurface layer (<4 µm).
Metadata
| Item Type: | Article |
|---|---|
| Authors/Creators: |
|
| Copyright, Publisher and Additional Information: | © 2026 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (https://creativecommons.org/licenses/by-nc-nd/4.0) |
| Keywords: | Micromilling; Residual stresses; Titanium alloys; Machining |
| Dates: |
|
| Institution: | The University of Sheffield |
| Academic Units: | The University of Sheffield > Faculty of Engineering (Sheffield) > School of Mechanical, Aerospace and Civil Engineering The University of Sheffield > University of Sheffield Research Centres and Institutes > AMRC with Boeing (Sheffield) The University of Sheffield > Advanced Manufacturing Institute (Sheffield) > AMRC with Boeing (Sheffield) |
| Date Deposited: | 20 Nov 2026 13:06 |
| Last Modified: | 20 Nov 2026 13:06 |
| Status: | Published |
| Publisher: | Elsevier BV |
| Refereed: | Yes |
| Identification Number: | 10.1016/j.procir.2026.02.106 |
| Open Archives Initiative ID (OAI ID): | oai:eprints.whiterose.ac.uk:248211 |
Download
Filename: 1-s2.0-S2212827126003781-main.pdf
Licence: CC-BY-NC-ND 4.0

CORE (COnnecting REpositories)
CORE (COnnecting REpositories)