Cai, N, Xia, S, Li, X et al. (7 more authors) (2021) High-value products from ex-situ catalytic pyrolysis of polypropylene waste using iron-based catalysts: the influence of support materials. Waste Management, 136. pp. 47-56. ISSN 0956-053X
Abstract
Catalytic pyrolysis is considered a promising strategy for the utilisation of plastic waste from the economic and environmental perspectives. As such, the supporting materials play a critical role in the properties of the catalyst. This study clarified this influence on the dispersion of the iron (Fe) within an experimental context. Four different types of typical supports with different physical structures were introduced and explored in a two-stage fixed-bed reactor; these included metallic oxides (Al2O3, TiO2), a non-metallic oxide (SiO2), and molecular sieves (ZSM-5). The results show that the liquid products were converted into carbon deposits and lighter gaseous products, such as hydrogen. The Al2O3-supported catalyst with a relatively moderate specific surface areas and average pore diameter exhibited improved metal distribution with higher catalytic activity. In comparison, the relatively low specific surface areas of TiO2 and small average pore diameters of ZSM-5 had a negative impact on metal distribution and the subsequent catalytic reformation process; this was because of the inadequate reaction during the catalytic process. The Fe/Al2O3 catalyst produced a higher yield of carbon deposits (30.2 wt%), including over 65% high-value carbon nanotubes (CNTs) and hydrogen content (58.7 vol%). Additionally, more dispersive and uniform CNTs were obtained from the Fe/SiO2 catalyst. The Fe/TiO2 catalyst promoted the formation of carbon fibre twisted like fried dough twist. Notably, there was interesting correspondence between the size of the reduced Fe nanoparticles and the product distribution. Within certain limits, the smaller Fe particle size facilitates the catalytic activity. The smaller and better dispersed Fe particles over the support materials were observed to be essential for hydrocarbon cracking and the subsequent formation of carbon deposits. The findings from this study may provide specific guidance for the preparation of different forms of carbon materials.
Metadata
Item Type: | Article |
---|---|
Authors/Creators: |
|
Copyright, Publisher and Additional Information: | Crown Copyright © 2021 Published by Elsevier Ltd. All rights reserved. This is an author produced version of an article published in Waste Management. Uploaded in accordance with the publisher's self-archiving policy. |
Keywords: | Waste plastics; Catalytic pyrolysis; Support materials; Hydrogen; Carbon nanotubes |
Dates: |
|
Institution: | The University of Leeds |
Academic Units: | The University of Leeds > Faculty of Engineering & Physical Sciences (Leeds) > School of Chemical & Process Engineering (Leeds) |
Depositing User: | Symplectic Publications |
Date Deposited: | 19 Nov 2021 15:54 |
Last Modified: | 20 Nov 2021 01:38 |
Status: | Published |
Publisher: | Elsevier |
Identification Number: | 10.1016/j.wasman.2021.09.030 |
Open Archives Initiative ID (OAI ID): | oai:eprints.whiterose.ac.uk:180005 |