This is the latest version of this eprint.
Merino Perez, J.L., Merson, E., Ayvar-Soberanis, S. et al. (1 more author) (2014) The Applicability of Taylor’s Model to the Drilling of CFRP Using Uncoated WC-Co Tools: The Influence of Cutting Speed on Tool Wear. International Journal of Machining and Machinability of Materials, 16 (2/2014). pp. 95-112. ISSN 1748-5711
Abstract
This work investigates the applicability of Taylor’s model on the drilling of CFRP using uncoated WC-Co tools, by assessing the influence of cutting speed (Vc) on tool wear. Two different resins, possessing low and high glass transition temperatures (Tg), and two different reinforcements, high strength and high modulus woven fabrics, were combined into three different systems. Flank wear rate gradient exhibited to be more reinforcement dependent, while the actual flank wear rate showed to be sensible also to the type of resin. In terms of tool life, all CFRP systems adjusted into a power-type tool life vs. cutting speed curve through the full range of cutting speeds (1,000 RPM to 18,000 RPM). Therefore, Taylor’s model can be applied to estimate the tool life in the drilling of CFRP using uncoated WC-Co tools with good accuracy.
Metadata
Authors/Creators: |
|
---|---|
Copyright, Publisher and Additional Information: | © 2014 The Author(s). This is an Open Access article distributed under the terms of the Creative Commons Attribution Licence (http://creativecommons.org/licenses/by/3.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. |
Keywords: | Taylor model; cutting speed; tool wear; flank wear; tool life; glass transition temperature; CFRP; SEM; drilling; machining; machinability |
Dates: |
|
Institution: | The University of Sheffield |
Academic Units: | The University of Sheffield > Advanced Manufacturing Institute (Sheffield) The University of Sheffield > Faculty of Engineering (Sheffield) > Department of Mechanical Engineering (Sheffield) |
Depositing User: | Symplectic Sheffield |
Date Deposited: | 03 Mar 2015 09:44 |
Last Modified: | 16 Nov 2015 11:36 |
Published Version: | http://dx.doi.org/10.1504/IJMMM.2014.064683 |
Status: | Published |
Publisher: | Inderscience Publishers |
Refereed: | Yes |
Identification Number: | https://doi.org/10.1504/IJMMM.2014.064683 |
Related URLs: |
Available Versions of this Item
-
The Applicability of Taylor’s Model to the Drilling of CFRP Using Uncoated WC-Co Tools: The Influence of Cutting Speed on Tool Wear. (deposited 11 Jun 2014 09:35)
- The Applicability of Taylor’s Model to the Drilling of CFRP Using Uncoated WC-Co Tools: The Influence of Cutting Speed on Tool Wear. (deposited 03 Mar 2015 09:44) [Currently Displayed]